Publicidad
Idiomas disponibles
Idiomas disponibles
Blinker
Antenna included
LED Bulb
Power cable
Bulb connection
power supply
Operating temperature
Dimensions
Protection rating
Photocells
Detection Method
Sensing Range
Input Voltage
Response Time
Operation Indicator
Dimensions
Output Method
Protection rating
Racks
Racks
Material
Length included
Remote control
Channels
Frequency - Maximum transmitted power
Power supply
Safety
Free-field range
F- MAINTENANCE
F- MAINTENANCE
Conduct the following operations at least every 6 months. If in high intensity of use, shorten the period in between.
Disconnect the power supply:
(1) Clean and lubricate the screws, the pins, and the hinge with grease.
(2) Check the fastening points are properly tightened.
(3) Make the wire connection are in good condition.
Connect the power supply:
(1) Check the power adjustments.
(2) Check the function of the manual release.
(3) Check the function of photocells or other safety device.
YES (coaxial cable not supplied)
E14 24V 10W (included)
≥ 0.5 mm² x2
(not included)
polarized at the electronic card connection.
24 V DC
-20°C~+50°C
74 x 167 x 59 mm
IP54
infrared beam
20 m max
AC/DC 12~24V
< 100ms
RX : Red LED On (beam broken) / Off (beam aligned)
TX : Red LED On (power supply)
95 x 45 x 43 mm
relay output
IP54
12 x 34 cm
nylon with steel insert
4 m (34 cm for each rack)
4
433.92 MHz - <1mW
1 CR2032 lithium battery (supplied)
rolling code technology
60 m
EN
37
Publicidad
