Publicidad
Idiomas disponibles
Idiomas disponibles
CARBURETOR
Your carburetor is not adjustable.
If your
engine does not operate properly due to
suspected carburetor problems, take your
lawn mower to a Sears or other qualified
service
center for repair and/or
adjust-
ment.
IMPORTANT:
Never tamper with the
engine governor,
which is factory set for
proper engine speed.
Overspeeding
the
engine above the factory
high speed
setting can be dangerous.
If you think the
engine-governed
high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment
and experience
to make any
necessary
adjustments.
Immediately
prepare
your lawn mower for
storage at the end of the season
or if the
unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly, remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
1. Clean
entire lawn mower
(See
"CLEANING"
in the Maintenance
section
of this manual).
2.
Lubricate
as shown
in the Mainte-
nance section
of this manual.
3.
Be sure that all nuts, bolts, screws,
and pins are securely
fastened.
Inspect moving
parts for damage,
breakage
and wear. Replace
if
necessary.
4. Touch
up all rusted or chipped
paint
surfaces;
sand lightly before
painting.
HANDLE
You can fold your lawn mower handle for
storage.
1. Squeeze
the bottom
ends of the lower
handle
toward each other until the
lower
handle clears
the handle
bracket,
then move handle
forward.
2.
Loosen
upper handle
mounting
bolts
enough
to allow upper handle
to be
folded
back.
IMPORTANT:
When folding
the handle
for storage or transportation,
be sure to
fold the handle as shown or you may
damage
the control
cables.
• When
setting
up your handle from the
storage
position,
the lower
handle will
automatically
lock into the mowing
position.
SQUEEZE
TO FOLD
Operator
control bar
Lower
han
FOLD
BACKWARD
Mowing
position
ENGINE
FUEL SYSTEM
IMPORTANT:
It is important to prevent
gum deposits from forming
in essential
fuel system parts such as carburetor, fuel
filter, fuel hose, or tank during storage.
Also, alcohol blended
fuels (called
gasohol or using ethanol or methanol)
can attract moisture which leads to
separation
and formation
of acids during
storage. Acidic gas can damage the fuel
system of an engine while in storage.
1. Drain the fuel tank.
2.
Start the engine and let it run until the
fuel lines and carburetor are empty.
15
Publicidad
