VITO PRO POWER VIBCSA20 Manual De Instrucciones página 24

Keep all bolts properly tightened so that the power tool is
in a safe operating condition.
If any components or safety devices are removed for
maintenance works,
immediately and correctly.
Use only VITO-approved accessories for this machine or
technically identical parts. Failure to do so may result in
personal injuries or damages to the blower/vacuum
cleaner. If in doubt, if you lack knowledge or resources, you
should contact an official dealer.
Your blower/vacuum cleaner should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts.
1. Insert the battery pack (7) into the blower/vacuum
cleaner slot and press the battery until you hear the
"click" of the lock/unlock button (6). At this point the
battery is fully secured;
2. To remove, press the lock/unlock button and pull out the
battery.
Use VITO's 20V lithium-ion batteries.
1. Place the battery (7) in the charger as you would place it
in the machine;
2. Plug the charger into the socket and let it charge.
Sometimes at the end of charging, both the battery and the
charger can be hot, but this does not mean that they are
malfunctioning.
Let the battery cool down before fitting into the machine.
1. Fit the tube (1) into the air outlet (2);
2. Turn the tube clockwise to tighten.
they must be repositioned
Never assemble or change the tube while the blower /
vacuum cleaner is running.
1. Fit the tube (1) into the air inlet (8);
2. Turn the tube clockwise to tighten;
3. Place the dust bag in the air outlet (2);
4. Turn the bag clockwise to secure.
Always empty the dust bag after use.
While operating the blower/vacuum cleaner you must
consider some precautions and procedures of use:
▪ Never vacuum/blow on hard objects such as stones,
bottles, cans or pieces of metal. Such objects may
damage the internal fan and cause injury to the user;
▪ To avoid motor damage due to overspeed, do not block
the inlet of the suction/blowing tube;
▪ Never put down the blower/vacuum cleaner before the
motor has completely stopped;
▪ Turn off the blower/vacuum cleaner immediately if any
of the following problems arise:
- Grease leakage from the ventilation slots;
- Damage on the housing;
- Damage on the ON/OFF switch;
- Appearance of smoke or a burning smell.
1. To switch on the blower/vacuum cleaner, press the
"ON/OFF" switch (3);
2. To turn the blower/vacuum cleaner off, release the
"ON/OFF" switch.