Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: Alcoholblendedfuels
(calledgasoholor usingethanolor metha-
nol)can attract moisturewhich leadsto
separationandformationof acidsduring
storage. Acidicgas can damagethe fuel
systemof an
engine while in storage, To
avoid engine problems, the fuel system
should be emptied before storage of 30
days or longer. Empty the gas tank, start
the engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel
next season, See Storage Instructions for
additional information.
Never use engine
or carburetor cleaner products in the fuel
tank or permanent damage may occur.
Engine
oil cap
Primer
Gasoline
filler cap
TO STOP
ENGINE
• To stop engine, release operator pres-
ence control bar.
TO START
ENGINE
NOTE: Due to protective coatings on the
engine, a small amount of smoke may be
present during the initial use of the prod-
uct and should be considered normal_
1oTo start a cold engine, push primer
three (3) times before trying to start.
Use a firm push. This step is not usually
necessary when starting an engine
which has already run for a few minutes.
2. Hold operator presence control bar
down to the handle and pull starter
handle quickly. Do not allow starter rope
to snap back.
NOTE: In coolerweatherit may be necessary
to repeat priming steps° In warmer weather
over priming may cause flooding and engine
will not start, If you do flood engine, wait a
few minutes before attempting to start and
do not repeat priming steps,
MOWING
TIPS
CAUTION:
Do not use de-thatcher
blade attachments on your mower. Such
attachments are hazardous, will damage
your mower and could void your warranty.
° Under certain conditions, such as very
tall grass, it may be necessary to raise
the height of cut to reduce pushing effort
and to keep from overloading the engine
and leaving clumps of grass clippings.
It may also be necessary to reduce
ground speed and!or run the lawn
mower over the area a second time.
= For extremely heavy cutting, reduce the
width of cut by overlapping previously
cut path and mow slowly.
• For better grass bagging and most cut-
ting conditions, the engine speed should
be set in the FAST position.
° For side discharge lawn mowers, cutting
in a counter-clockwise
direction, start-
ing at the outside of the area to be cut,
spreads grass clippings more evenly
and puts less load on the engine. To
keep clippings off of walkways, flower
beds, etC.r,make the first cuts in a clock-
wise direction.
° Pores in cloth grass catchers can be=
come filled with dirt and dust with use
and catchers will collect less grass. To
prevent this, regularly hose catcher off
with water and let dry before using.
• Keep top of engine around starter clear
and clean of grass clippings and chaff.
This will help engine air flow and extend
engine life.
MULCHING
MOWING
TIPS
IMPORTANT:
For best performance,
keep mower housing free of built-up
grass and trash_ See "CLEANING" in the
Maintenance section of this manual.
° The special mulching blade will recut
the grass clippings many times and
reduce them in size so that as they fall
onto the lawn they will disperse into
the grass and not be noticed. Also, the
mulched grass will biodegrade quickly
to provide nutrients for the lawn. Always
mulch with your highest engine (blade)
speed as this will provide the best recut-
ting action of the blades.
° Avoid cutting your lawn when it is wet.
Wet grass tends to form clumps and
interferes with the mulching action. The
best time to mow your lawn is the early
afternoon.
At this time the grass has
dried, yet the newly cut area will not be
exposed to direct sunlight.
9
Publicidad
