Publicidad
Idiomas disponibles
Idiomas disponibles
CHAIN OIL
Use appropriate oil for chains.
NOTE
Never use wasted or regenerated oil, as this can cause the oil pump is damaged.
NOTE
Remember that the chain lubrication's regulator can only be twisted in a 1/4 (right
or left).
On the contrary; if you twist the regulator too much, you may break the stopper.
ENGINE OPERATION
It is very dangerous to operate a chainsaw when its components are damaged or missing. Before
starting the engine, make sure that all components, including the bar and chain are installed properly.
START
1. Fill tanks of fuel and chain oil and adjust lids
2. Press constantly priming bulb until fuel reaches the bulb.
3. Push the throttle and the lever with trigger lock.
4. Pull the choke knob out to second. The throttle will close and the throttle will start position.
WARNING!
When the engine starts immediately after stopping, leave the choke knob in the
open position.
5. With the saw unit securely on the ground, firmly pull the starter rope.
WARNING!
Never try to start the engine holding the greencut with hands. This is extremely
dangerous, as the chain greencut can touch your body.
6. Once ignition occurs, press the throttle to enter, to the first position again and pull the
starter rope to start the engine.
7. Let the engine warm up keeping the throttle slightly pulled.
EN I 73
Publicidad
