Publicidad
Idiomas disponibles
Idiomas disponibles
• If the unit is not working as it should, has been
dropped, damaged, left outdoors or dropped into
water, contact Uline Customer Service.
• Do not pull or carry by the cord, use the cord as a
handle, close a door on a cord or pull cord around
sharp edges or corners.
• Do not run the unit over the cord.
• Do not handle the plug or the unit with wet hands.
• Do not store near hazardous materials.
• Do not allow it be used as a toy. Close attention is
necessary when used by or near children.
• To reduce the risk of injury from accidental starting,
unplug power cord before cleaning, making
adjustments or repairing.
• Turn off all controls before unplugging.
• Do not use unit with any solid-state speed control
device.
1.
Ensure machine is in a safe operating location. Do
not place machine in a puddle, and make sure it is
protected from drips and splashes.
2. Plug the power cord into a grounded electrical
outlet. Always unwind power cord completely before
operating machine. Inspect power cord for damage
before each use. Replace cord immediately if
damaged.
3. Place the machine in the desired operating position.
(See Figure 2)
a. Horizontal – Dry floors and carpets.
b. Tilted – Dry floor finishes, paint, etc.
c. Vertical – Dry wall and ceiling.
a
Figure 2
PAGE 2 OF 9
SAFETY CONTINUED
OPERATING INSTRUCTIONS
b
c
• Do not put any object into ventilation openings. Do
not operate with any ventilation openings blocked.
Keep free of dust, lint, hair or anything that may
reduce air flow.
• Keep hair, loose clothing, fingers and all parts of
the body away from openings and moving parts.
• To reduce the risk of falls, use extra care when
using the unit on stairs.
• Do not pick up flammable or combustible liquids,
such as gasoline, or use in areas where they may
be present.
• Do not use an extension cord with this unit.
• If the machine tips over during use, shut it off
immediately, set it upright and wait for the motor
to stop completely.
• Do not use machine in standing water.
NOTE: Save this manual for future reference.
4. Set the desired speed by turning switch.
5. Check for proper operation before leaving the
machine unattended. Do not move or carry the
machine when it is operating.
6. To shut off machine, turn the switch to the off (O)
position. (See Figure 3)
Figure 3
7. The machine is equipped with an automatic reset
motor overload shutoff thermal sensor to protect
motor from overheating. Should the shutoff thermal
sensor trip, it will reset automatically when the motor
has cooled sufficiently, usually after 15-30 minutes.
0623 IH-10948
Publicidad
