Wurkkos HD15 Manual Del Usuario página 5

When HD15 is ON:
Consecutiv
Action
e Action
Hold
Click +
Hold
1 click -
2 fast
clicks
2 clicks
2 clicks
2 clicks
1 click
Operating HD15 for a long time on high brightness modes or while reverse
charging will warm the flashlight up. This is normal.
Troubleshooting and Maintenance
 Disassembling the sealed head can damage the flashlight and voids the
warranty.
 Wurkkos Ltd. recommends using high-quality brand batteries. Damage by
defective batteries void the warranty.
 Remove the battery if the flashlight will not be used for an extended period
of time.
 To prevent self-discharge or accidental activation during storage or
transportation, unscrew the tailcap by half a turn or remove battery.
 Every 6 months threads should be wiped with a clean cloth followed by a thin
layer of silicone grease.
 To maintain a proper level of waterproofness, replace worn-out o-rings with
an approved spare (2 pieces are shipped with initial order).
Change brightness (low > medium > high) on current LED
Cycle LED modes (spotlight only > floodlight only > both
Selected brightness for each LED mode and which LED mode
was last used are memorized
Activate Turbo mode (last used LED mode)
Cycle to Strobe mode (both LEDs at full power)
Cycle to SOS mode (both LEDs at full power)
Cycle to Beacon mode (both LEDs at full power)
Return to previous standard mode from any of these
modes. Another single click will turn OFF the light.
Triggered Result
selection
LEDs)
Turn OFF