monzana MSPM900 Manual De Instrucciones página 29

appliance open slightly. This will maintain the seals for longer and odours will not develop in
the appliance.
10.1.1 CLEANING THE FILTERS
The filters 6 and 7 can prevent larger particles of food in the water reaching the pump. These
particles can clog the filters.
 Check the filters for food residue after washing the appliance and clean them if necessary.
 After filter 7 has been removed, the filter screen 6 can be taken out. Remove any food residue
and rinse the filters under running water.
 Insert filter screen 6 and secure filter 7.
10.1.2 CLEANING THE SPRAY ARM
Limescale and food residue in the washing water can clog the nozzles of the spray arms.
 Check the nozzles in the appliance for any holes clogged with food residue.
 If necessary, pull the spray arm up and remove it.
 Clean the spray arms under running water.
 Re-attach the spray arms.
11.0 ERROR MESSAGE
Display Problem
problem
E1 Water supply
disrupted
E2 Alarm of the
temperature
sensor
E4 Heating alarm
E5 Communication
Tap control No water supply
light
OP The door is
open
Possible cause
1. Problem with the inlet
valve or the outlet valve
2. Problem with the flow
meter
3. Problem with the water
pump
The temperature sensor is
not connected correctly or
is defective
Heating device or
temperature sensor has a
problem
Communication problem
Not enough water in the
water tank
The door is not closed or
the power cable is
defective.
29
Note
If the user does not fill the
water tank with enough
water and then starts the
appliance, the error E1 will
be displayed. The user can
pour in enough water until
the tap symbol (g) goes off
in order to resolve this
problem.
Repair by a specialist
Repair by a specialist
Repair by a specialist
Fill with water or open tap.
Close the door or arrange
for a specialist to replace
the power cable.
www.DEUBAXXL.de