Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
UNPACKING
This product requires assembly.
z Carefully remove the product and any accessories from
the box. Make sure that all items listed in the Packing
List are included.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
WARNING:
Do not use this product if any parts in the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
z Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
z Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
z If any parts are damaged or missing, please call
1-800-776-5191 for assistance.
PACKING LIST
Pressure Washer
25 ft. High Pressure Hose
Trigger Handle
Trigger Handle Holder
Storage panel
Spray Wand
Soap Injection Hose with Filter
Quick-Connect Nozzles (3)
4-Cycle Engine Lubricant (SAE 30 or SAE 10W30)
Disposable Funnel
Handle
Wheel (2)
Axle (2)
Hitch Pin (2)
Screws (3)
Nuts (3)
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
ATTACHING THE WHEEL ASSEMBLY
See Figure 2.
z Locate the axles, hitch pins, and wheels.
z Slide the axle through the hole in the center of the wheel.
z Lift the machine and slide the combination into the wheel
mounting hole in the machine base as shown.
z Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
z Repeat with the second wheel.
INSTALLING THE HANDLE
See Figure 3.
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
z Push and hold the buttons on the frame as you slide the
handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock but-
ton snaps through the locking slot to secure the handle
in place.
INSTALLING THE STORAGE PANEL AND
TRIGGER HANDLE HOLDER
See Figures 4 - 5.
z Align the holes in the storage panel with the holes in the
handle, as shown.
z Insert screws through the left holes (when viewed from
front). Install nuts and tighten securely using a Phillips
screwdriver and 10 mm wrench (not provided).
z Align the trigger handle holder with the holes in the handle
and panel on the opposite side, as shown.
z Insert the remaining screws through the holes, then install
the nuts and tighten securely.
7 – English
Publicidad
