Descargar Imprimir esta página

Scheppach TB200 Traduccion Del Manual De Instrucciones Originale página 8

Buscapolos

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
1
Phase tester
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
ATTENTION
Attention!
When using products, several safety warnings must
be observed to prevent injuries and damage. For this
reason, please carefully read this operating manual /
safety instructions. If you hand the product over to
another person, please hand over this operating man-
ual / safety instructions as well. We accept no liability
for accidents or damage that occur due to a failure to
observe this manual and the safety instructions.
WARNING
The voltages specified on the phase tester are rated
voltages. The phase tester may only be used at the
specified voltage or within the specified voltage
range.
DANGER
Danger to life due to electric shock!
• Phase testers may only be used to determine and
check the phase conductor.
• Phase testers are not designed for use on live
equipment in order to determine the state (operating
voltage present or not present) of low-voltage sys-
tems.
• Only use the phase tester in the voltage range from
125 to 250 volts ~.
• Do not use a defective phase tester whose function
and/or safety is clearly impaired.
• The phase tester must always be checked for prop-
er function shortly before use.
• Only use the phase tester in dry conditions.
• The sealing caps must not be removed. If the cap or
the housing has been opened, the phase tester may
no longer be used as safety is impaired.
• The phase tester must not be used when exposed
to precipitation such as dew or rain.
• Damaged phase testers whose function and/or
safety is obviously impaired must not be used.
WARNING
Never use the phase tester as a screw-
driver on live system parts.
8 | GB
Before each use:
1. The phase tester and the insulation sheath must al-
ways be checked for proper function shortly before
use. Damaged phase testers must not be used.
2. Check the function of the glow lamp of the phase
tester on a connected socket. Dispose of damaged
or malfunctioning phase testers immediately.
WARNING
Not noticing the light indicator does not
guarantee freedom from voltage.
ATTENTION
The following factors may affect the per-
ceptibility of the indicator light:
Unfavourable lighting conditions, e.g. sunlight.
Temperatures outside the range of -15 °C to +40 °C.
Frequencies outside the range of 50 to 500 Hz.
Unfavourable locations such as on wooden steplad-
ders, insulating floor coverings and in AC networks
that are not operationally earthed.
To determine whether an AC voltage is present,
carry out the following steps:
1. Hold the tip of the phase tester against a contact of
the electric lead.
2. And touch the other end of the phase tester with a
finger.
If AC voltage is present, the glow lamp lights up.
2
Disposal and recycling
Notes for packaging
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of separate-
ly!
• Used batteries or rechargeable batteries that are
not installed permanently in the old appliance must
be removed non-destructively before disposal. Their
disposal is regulated by the battery law.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
www.scheppach.com
The packaging materials are re-
cyclable. Please dispose of pack-
aging
in
an
environmentally
friendly manner.

Publicidad

loading

Este manual también es adecuado para:

5909310900