Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
ABRASIVE
BELT
Refer to Figure 18.
• Sanding belt should be replaced when worn, torn, or glazed.
Remove table assembly and support rod or work stop.
• Remove bracket, deflector and cover.
NOTE= Model 215690 - also need to remove mount and two
screws (Fig. 22, Key. Nos. 13 and 14).
• Release belt tension by pushing tension lever toward idler
drum. Slide old belt off the drive and idler drums.
NOTE: There may be an arrow on the inside of the belt. The
arrow should point in the direction of belt travel to ensure that
the splice in the belt will not come apart.
• Slide new belt over the drive and idler drums; center belt
on drums.
• Additional abrasive belts are available (See Recommended
Accessories, page 15).
• Push tension lever towards drive drum to tension belt.
• Check tracking. See "Adjusting Belt Tracking", page 6.
• Replace bracket, deflector and cover.
NOTE: Model 215690 - also replace mount and screws.
_crews
Figure 18 - Remove Cover first, Deflector and then Bracket
REPLACING
ABRASIVE
DISC
Refer to Figure 19.
• Remove table assembly.
• Remove disc cover by loosening and removing six screws.
• Remove old abrasive disc by peeling it from the aluminum
disc. Removing aluminum disc is not necessary.
• Clean aluminum disc ff necessary. Select the desired abra-
sive disc and apply to aluminum disc.
• Additional abrasive discs are available (See
Recommended Accessories, page 15).
• Replace disc cover.
Figure 19 - Removing Disc Cover
WARNING:
Make certain that the unit is disconnected from
power source before attempting to service or remove any
component.
CLEANING
Keep machine and workshop clean. Do not allow sawdust to
accumulate on the tool. Keep the drums clean. Dirt on drums
will cause poor tracking and belt slippage. Periodically empty
the dust collection bag.
Be certain motor is kept clean and is frequently vacuumed
free of dust.
Use soap and water to clean painted parts, rubber parts and
plastic guards.
LUBRICATION
The shielded ball bearings in this tool are permanently
lubricated at the factory. They require no further lubrication.
• When operation seems stiff, a light coat of paste wax
applied to the belt table and disc table will make it easier to
feed the work while finishing.
• Do not apply wax to the belt platen. Belt could pick up wax
and deposit it on wheels causing belt to slip.
KEEP TOOL IN REPAIR
• If power cord is worn, cut, or damaged in any way, have it
replaced immediately.
• Replace worn abrasives when needed.
• Replace any damaged or missing parts. Use parts list to
order parts.
Any attempt to repair motor may create a hazard unless
repair is done by a qualified service technician. Repair
service is available at your nearest Sears store.
9
Publicidad
