Publicidad
Idiomas disponibles
Idiomas disponibles
EN
These instructions are designed for the installation
engineer to assemble the product and for the user to
operate and maintain it. After installation, please pass
them on to the user for safekeeping.
Symbols and their meaning
Caution! Warning of personal injury or material
damage
Caution! Warning of electric shock.
Caution! Warning of water damage.
Note, tip or reference
Correct assembly/functional test
Incorrect assembly
Observe assembly details
Optional/accessories
Confi rmation tone/click sound
Observe enclosed documentation!
Safety Information
– The electrical installations must be undertaken by a
specialist electrical installer in compliance with IEC
60364-7-701/VDE 0100 Part 701! National and local
regulations must be taken into consideration!
– Do not start the appliance if it or the power sup-
ply cable is damaged, but have it replaced by the
manufacturer, its customer service or by an equally
qualifi ed person.
Prior to installation it must be ensured that the wall
can support the weight of the mirror.
To prevent personal injury or material damage the
assembly must be carried out by two persons.
The product is suitable only for mounting indoors!
Caution! Only install in frost-free rooms.
4
Important information, please make sure to read!
Declaration of conformity! This product complies with
the requirements of the valid EU Guidelines. The dec-
laration of conformity for this product can be requested
from the following address:
KEUCO GmbH & Co. KG, Oesestraße 36,
D-58675 Hemer.
Technical data
– Supply voltage:
– Max. power consumption:
Prod. No.:
3285W XX01V0
3286W XX01V0
Push-button
– Protection category:
– Ambient conditions:
Temperature
– Luminous colour
Mounting dimensions, see page 2.
Installation, see fi gure 1 onwards on page 12.
Connection, refer to fi gure 7a and 7b on page 13.
Operation
Connection type I, see fi gure 7a: When operating with a 4-wire
connection cable, the lighting can be switched with an external
light switch A or the push button B.
The socket and the USB charger are permanently supplied
with voltage.
Connection type II, see fi gure 7b: When operating with a 3-wire
connection cable, the lighting can only be switched via the
push button B.
The socket and the USB charger are permanently supplied
with voltage.
The light sources may only be replaced by the
manufacturer, its customer service or by an equally
qualifi ed person.
For information about warranty and maintenance, see
the enclosed Care Instructions and Warranty Card.
Disposal information! Equipment with this labelling
must not be disposed of in household refuse, but must
be disposed of at a collection centre intended for this
purpose.
220-240V AC 50/60Hz
Width
Light
650 mm
10 W
800 mm
12 W
36 W
5° – 40° C
3000 Kelvin
L
= black
N
L´
IP20
Publicidad
