Descargar Imprimir esta página

Craftsman 536.885201 Manual Del Operador página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

The operation of any snow thrower can
result in foreign objects being thrown
into the eyes, which can result in se-
vere eye damage.
Always wear safety
glasses or eye shields while operating
the snow thrower.
We recommend standard safety
glasses or a wide vision safety mask for
over your glasses.
,_
WARNING: Read Owner's
Manual before operating
machine. Never direct dis-
charge toward bystanders stop the
engine before unclogging discharge
chute or auger housing and before
leaving the machine.
TO STOP YOUR
SNOW THROWER
1. To stop throwing snow, release the
auger drive lever.
See Figure 3.
NOTE: If the snow thrower contin-
ues to slowly move forward, see
"How To Adjust The Auger Control
Cable" in the Service And Adjust-
ment Section.
2. To stop the engine, move the igni-
tion lever to the off position.
TO CONTROL
SNOW
DISCHARGE
1. Turn the chute control rod to set the
direction of the snow throwing.
2. Loosen the wing knob on the chute
deflector and move the deflector to
set the distance. Move the deflector
(Up) for more distance, (Down) for
less distance. Then tighten the
wing knob (See Figure 4).
Deflector Down
Deflector Up
HOW TO THROW SNOW
1. Engage the auger drive lever.
2. To stop throwing snow, release the
auger drive lever.
,_
WARNING: The operation of
any snow thrower can result
in foreign objects being
thrown into the eyes, which can re-
sult in severe eye damage.
Always
wear safety glasses or eye shields
while operating
the snow thrower.
We recommend
standard safety
glasses or use a wide vision safety
mask over your glasses.
HOW TO MOVE FORWARD
1,
2.
Hold the auger drive lever against
the handle (See Figure 5). The au-
ger will begin rotating.
To go forward, raise the handle to
allow the rubber auger blades to
contact the ground. Maintain a firm
hold on the handle as the snow
thrower starts to move forward.
Guide the snow thrower by moving
the handle either left or right. Do
not attempt to push the snow throw-
er.
3. To stop, release the auger drive le-
ver.
NOTE: If the auger continues to rotate,
see "How To Adjust The Auger Control
Cable" in the Service and Adjustments
section.
Wing Knob
Figure 4
F-011060M
10
Figure 5

Publicidad

loading