Sonia Limb HZ-3815B Manual Del Usuario página 3

SKETCH AND DIMENSIONS
INSTRUCTIONS FOR ASSEMBLY
● Place the wooden base and draw under the table, so that
the holes in the metal structure line up with the screw
holes.
● Insert the screws and tighten them evenly with the
appropriate tool.
● Place the 4 wooden trims onto the metal structure,
pressing with your hands to ensure that the Velcro is
properly stuck on.
● For the 2 longer trims, remember that there are grooves
inside. These grooves indicate the side of the structure on
which they must be installed to fit properly.
● Insert the armrest in the correct position so that the pin
fits with the plastic part of the stretcher body and push it
in until the stop.
● Perform the same procedure on the 2 armrests.
OPERATION
● Connect the bed to an electrical outlet using the power
cord.
● Hand controller
1 2
3 4
5 6
- Press the button
to activate the control knob. The
red indicator will light up and all its functions can be
used.
- Adjusting height
• Use the buttons 1 and
adjust the bed height.
- Adjusting backrest tilt
• Use the buttons and
3
adjust the tilt of the backrest.
- Press the button
. repeatedly to change the colour
5
of the LED lights on the base. After five presses, it will
enter cyclic colour mode, and with one more press it will
turn off.
- Press the button
to adjust the power of the LED
6
lights on the base. Pressing repeatedly will decrease the
brightness until reaching a minimum level, after which it
will begin to increase again.
2 of the hand controller to
of the hand controller to
4
EN
3