Descargar Imprimir esta página

Glacier bay HD67818W-6110H Guía De Uso Y Mantenimiento página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
Shut off the water supply. Remove the old
faucet.
Clean the mounting surface.
Remove the preassembled lock nuts (E) and
washers (C & D) from the new faucet (A).
Before installation, ensure that the ange (B) is
placed on the bottom of the new faucet (A).
Place the faucet (A) through the mounting holes
in the sink until the faucet (A) sets on top of the
sink.
Secure the faucet (A) to the sink using the
washers (C & D) and lock nuts (E) provided.
NOTE: Ensure the washers (C & D) and hoses (1) are no
interference.
A
B
1
C
D
E
2
Preparing the drain assembly
Remove the bottom gasket (H) and nut (I) from
the top gasket (F) and drain body (G).
Attach these pieces together by pushing the
bottom gasket (H) down into the top of the
nut (I) and twisting together.
4
F
G
H
I

Publicidad

loading