Engel LE 4390 ATV Manual De Usuario página 98

BASIC OPERATION
Turning the TV on and off
· · Turn on the TV
Connect the energy cable. At this time the TV will enter standby mode, press the button on the
remote control to turn on the TV from standby mode.
· · Turn off the TV
Press the button on the remote control to enter standby mode.
Do not leave your computer in standby mode for long periods of time. It is best to disconnect the
whole of the electrical network and the antenna.
· · No signal
There is a No Signal menu on the screen when there is no input signal. In TV / DTV mode, if there is
no signal within fifteen minutes, the TV will automatically turn off.
Program selection
· · Use of CH + / CH- on the TV panel or remote control.
Press CH + to increase the channel number.
Press CH to decrease the channel number.
· · Use of digital buttons 0-9.
You can select the channel number by pressing 0 to 9. (In TV, DTV mode)
Adjusting the volume
· · Press the VOL +/- button to adjust the volume.
· · If you want to turn off the sound, press MUTE.
· · You can release the silence by pressing MUTE or increase / decrease the volume.
Changing the input source
You can select the input source by pressing the button on the remote control.
Press the / button to scroll through the input source and press the OK button to confirm your
choice.
98