Publicidad
Installation Instructions/Instrucciones de Instalación
LACAVA
1. Place the cartridge bodies up through their designated
holes. Then slide a handle onto each extension and
thread onto the brass body.
2. Tighten each locking nut from under the mounting surface.
(DO NOT OVERTIGHTEN: avoid damage to mounting
surface)
3. Remove the mounting hardware from the spout assembly.
Unscrew the pop-up knob from the vertical pop-up control
rod and then slide the rod through the slot on the back
of the mixer body. Then screw the pop-up knob back into
place.
4. Place the spout into the hole in the mounting surface and
tighten the mounting nut from under the mounting surface.
4
Publicidad
