Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
When the distance between the transmitter and receiver is too far, the message "Out of Range"
appears in the display and you hear a beep. Move the receiver nearer to the transmitter. If
necessary, optimum range can be achieved if both the Baby unit and Parent unit
antennas are extended vertically.
Registration
In delivery state the transmitter is pre−registered at the receiver (Watch&Care V132: both
transmitters).
If necessary or if a another camera is added to the system, registration can also be completed
manually:
1 Switch the transmitter off (switch set to OFF). Remove the batteries of the receiver for a few
seconds if necessary.
2 Switch the receiver on.
3 Press and hold down the button
until [C1] appears in the display.
4 Use the
buttons to select the desired camera [C1] ... [C4].
5 Press the
button briefly. The Link LED flickers for approx. 10 seconds. During this time,
you must perform steps 6 and 7.
6 Switch the transmitter on (switch set to ON).
7 Press the registration key on the back side of the transmitter.
After a short time the video from the transmitter will appear on the screen if the registration was
successful. If the registration failed, "Out of Range" appears on the screen.
Appendix
Safety Information
Please read this operating instruction manual thoroughly.
Intended use
The surveillance system has been developed to monitor rooms. The transmitter sends acoustic
and video signals from its point of installation to the receiver. Any other use is considered
unintended use.
The use of this equipment does not substitute personal supervision, e.g. of a child. Users are not
relieved of their personal liability. Unauthorised modification or reconstruction is not permitted.
Under no circumstances open the device or complete any repair work yourself.
Installation location and safety information
• Never lay the transmitter in a baby's/child's bed or playpen.
• Ensure that the transmitter and power cable are out of reach of babies/children, i.e. they are at
least one meter away.
• Pay attention that the components are sufficiently well−ventilated when in operation. Do not lay
a cushion, towel or such over the devices.
• The devices are not intended for medical purposes. Warning and signal tones from respiratory
P-9
Publicidad
Tabla de contenido
