Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTION
Position your completed mantel close to its final location. Make sure you can access the back of the
mantel as your electric fireplace appliance will be installed from back.
Using a Phillips head screwdriver, remove the
screws and the metal mounting center opening.
Next unpack the electric fireplace appliance
carefully. Position the appliance behind the
fireplace with front facing the wood mantel. With
the help of an adult assistant, lift the appliance
and gently slide it into the opening in the mantel.
Make sure the appliance is centered left and
right in the opening. Be careful when placing
appliance and adjusting, bottom of appliance
could scratch the finish of the base/hearth of
your fireplace. Re-attach the mounting brackets
with the Phillips head screwdriver, and supplied
screws.
DO NOT OVER TIGHTEN. With the help of an
assistant, carefully lift completed unit and place
it with the front facing out in the final location you
have chosen for your fireplace. Make sure to
secure the electrical cord before lifting or
moving completed fireplace. When choosing a
final location, make sure you will have clear
access to grounded electrical outlet.
GROUNDING INSTRUCTIONS:
This heater is for use on 120 volts. The cord has
a plug as shown at (A) in figure 2. An adapter as
shown at (C) is available for connecting
three-blade grounding-type plugs to two-slot
receptacles. The green grounding lug extending
from the adapter must be connected to a perma-
nent ground such as a properly grounded outlet
box. The adapter should not be used if a
three-slot grounded receptacle is available.
NOTE: Adapters are NOT for use in Canada
ELECTRICAL SPECIFICATIONS
Voltage: 120VAC 60Hz
Watts: 1400 Watts
≥1.5"
ELECTRIC
FIREPLACE
INSERT
≥1"
≥1"
（A）
Grounding Pin
Cover of Grounded Outlet Box
Adapter
Grounding Lug
Metal Screw
Cover of Grounded Outlet Box
3
ELECTRIC
FIREPLACE
INSERT
≥1.5"
≥1"
≥1"
（B）
REAR VIEW OF FIREPLACE
Figure 2
A
B
C
Publicidad
