Timbela M101 Manual Del Usuario página 15

finishing product (paint, wood preservative or impregnation agent) should be applied to outer and inner sides
of the shed- to protect the wood from cracks, from deformation because of the sun and rain influence. By
regularly applying a new finishing layer the life of your shed shall be lengthened. This should be repeated
every 3 years. If assembly is stopped, all parts which have not been assembled must be sheltered and stored
in a protected place, protected from sun, rain and humidity. Do not set up the shelter in very cold (frost) or
very hot weather. The shelter must be assembled in mild temperatures between 15 and 25 ° C. To avoid any
potential problem during assembly, carried out by you or by the construction company of your choice, we
recommend that you check that the parts of the shelter received are in accordance with the parts list before
assembly. This inspection must be carried out within 14 days of delivery to the location of your choice.
Warranty claims are limited to the exchange of defective materials. Defective construction parts that have
already been used or painted are excluded from the replacement warranty. All other requests are excluded!
In the event of a complaint, please follow the following procedure: send the supplier the inspection form on
the last page of the notice accompanied by the purchase invoice. Using step-by-step instructions and
provided sketches, you can easily assemble your garden shed.
FLOOR (IF PRESENT)
The floor can be composed of plates to be positioned or boards to be nested one inside the other. The floor
must be treated in the same way as the other pieces of wood in the shelter before being laid. It is also
possible to acquire a floor when it is not supplied. This floor must be adapted to the shelter.
WOODEN WALLS
The planks making up the four walls of the shelter must fit one above the other. Some planks may be slightly
warped because wood is a living material. In the case of veiled planks, use a clamp, a rubber mallet and a
chock block. For this, put the clamp in place to align the male part and the female part then place the wedge
on the veiled plank. Then, strike lightly with the rubber mallet until the veiled plank is inserted on the
previous plank. Be careful not to hit too hard as this could cause the plank to break or be damaged.
Make sure that the male part of the plank is always facing the roof when mounting the planks. Once the logs of
the shelter base and the orthogonality of the base and the diagonals verified, the other logs can be mounted. It
will then be possible to fix the brackets on the planks of the structure to avoid any damage during strong winds.
Continue to assemble the structure with the planks following the construction diagrams. Take care when
mounting the position of the planks in the orientation of the doors and windows. Take care when mounting the
position of the planks in the orientation of the doors and windows.
15