Publicidad
Idiomas disponibles
Idiomas disponibles
TO REMOVE DUST BAG
WARNING
Pull out on the
bag cover
release located
near the top of
the bag cover.
Bag Cover
Release--F_
Bag
lilt
Cover q
_
I
Grasp the dust bag
collar and pull gen-
tly, carefully remov-
ing the dust bag.
Throw away the
used dust bag.
Do not reuse.
Pull the bag
cover forward
and lift up.
Remove and
lay aside,
Bag
BagHolder Check the bag
holder and the
- BagCavity motor safety fil-
ter. If either is
blocked, check
safety
TROUBLE-
Filter
SHOOTING.
3 CAUTION
NEVER REUSE A DUST BAG.Very
fine materials, such as carpet
freshener, face powder, fine dust,
plaster, soot, etc. can clog the bag
and cause it to burst before it is
full. Change bag more often when
vacuuming these materials.
TO REPLACE DUST BAG
Unfold the
new dust bag.
O.st
Fold the safety
Bag
seal tab on the !l.___/_-_.._.sa,_ty
a_'-
new dust
bag
_f____S_al
b
away from the
opening that
fits on the bag
holder.
NOTE: See PARTS AND FEATURES
for
Bag number.
Tuck the bag
behind each of
the four bag
retention corner
flaps shown here.
Be sure the bot-
tom and sides of
the dust bag are
completely within
bag cavity prior to
replacing the bag
cover.
Insert the dust bag
onto the bag holder
completely by holding
the bag collar.
Place the dust bag
collar into position.
Sag
Retention
Corner
Flaps
Slots_
Close the bag
cover.
You will hear a
distinct snap
when cover is
securely closed.
Check to see
that the dust
Position the bag
cover so its
positioning tabs
fit into the body
positioning tab
slot&
bag is fully enclosed in the bag cover.
14
Publicidad
