Frigidaire FPWD2785KFA Instrucciones De Instalación

Canada
INSTALLATION AND SERVICE MUST BE PERFORMED
BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
_FOR YOUR SAFETY: Do not store or use gasoline or other
flammable vapors and liquids in the vicinity of this or any other appliance.
United States
GENERAL INFORMATION - The Warmer Drawer can
be used as a stand alone appliance or as a combination
Warmer Drawer with a built-in oven mounted above.
IMPORTANT: The warmer drawer must be installed on a
surface leveled from left to right, rear to front and the surface
must be capable of supporting 100 pounds (45,4 Kg).
Warmer Drawer Dimensions
NOTE: A 60" (152,4 cm) long cable is supplied with IMPORTANT: The Warmer Drawer runs off a single
the Warmer Drawer. phase three-wire 120 volt, 60 hertz, AC only electrical
/--Warmer Drawer
"'-.1€ Cutout
/
supply with ground.
Combination Warmer Drawer / 27" (68,6 cm) or
30" (76,2 cm) Built-in Oven Installation
Caution: Two 3" (7,6 cm) wide X
3A" (1,9 cm) thick planks have to be
installed and they should be able to
support 200 pounds (90,7 K
29 _/16" _ E
(73,8 cm)
H_ =11 7/8"(30,2 cm) Min.is the space between the
bottom of the drawer cutout and the bottom of the
oven cutout. This is a critical dimension and must be provided.
J** = 3" (7,6 cm)Max. Electrical Junction Boxfor wall oven can be
lower than warmer drawer cutout.
iiiiiiiiiii! i!!i!i ! ! i i i i i i ii ii ii i! i i !! !i i!i ii ii ii ii ii ii i! i i ii i iiiiiiiiiiiiiiii iiii i iiiii i
27" Models 11_/_" ( 28,6cm) 27"(68,6cm) 23_/_" (59,4cm)
30" Models 11_/_" ( 28,6cm) 30" (76,2cm) 23_/_" (59,4cm)
27" Models-Min. 97/_"(25,1cm) 25_/_" ( 64,8cm) 23%" (60cm)
Max. 10Y_" (26cm) 25_/_" ( 65,4cm) 24" (61cm)
30" Models-Min. 97/_"(25,1cm) 28_/_" ( 72,4cm) 23Sly" (60cm)
Max. 10Y_" (26cm) 28_/_" ( 73cm) 24" (61cm)
_eec¢
* Note: It is also possible to install this warmer drawer in a height opening
of 9V4" (23,5 cm). Please refer to page 3 for complete instructions.
Printed in United States
P/N 318201822 (0901) Rev. A
English - pages 1-4
Espaflol- p_iginas 5-8
Fran_ais- pages 9-12