Características Técnicas - Ecler essentials eMIMO1616 Manual De Usuario

10. CARACTERÍSTICAS TÉCNICAS
DSP
DSP
Sampling Rate
Latency IN to OUT
AD/DA Converters
Resolution
Dynamic Range
Analogue
Input 1-4- (LINE)
Input 5-8 (MIC/LINE)
Input 9-16 (Remote)
External MUTE
Frequency response
(+0dB / -0.5dB)
Flatness
THD+Noise @ 1kHz,
1Vrms
Output Noise floor FFT
(20Hz - 20kHz)
Interchannel crosstalk
(20Hz - 20kHz)
CMRR 20Hz- 20kHz
Processing
Input Level (x16)
Input Noise Gate (x4)
Floating point 32/64bit
48kHz
<1.5ms
24bit AKM
AD:111dB, DA: 115dB
Sensitivity: +5 / -15dBV External potentiometer adjust
Input impedance: >13k
Input connector: RCA female. Input 1 and 2 with EUROBLOCK stack
Input type: Unbalanced
Sensitivity: +0 / -50dBV External potentiometer adjust
Input impedance: >24k electronically balanced
CMRR: >60dB (20Hz ÷ 20kHz)
Input connector: Terminal block (Symmetrical)
Pagers: Input 7 and 8 (by RJ45 connector)
Input type: Balanced
Phantom voltage: +48VDC
Sensitivity: 0 dBV without adjustment.
Input impedance: >24k electronically balanced
CMRR: >60dB (20Hz ÷ 20kHz)
Input connector: RJ45 Connector
Input type: Balanced
Normally open. Assignable to any output zone
<10Hz ~ 20kHz
better than ±0.1dB
< 0.005%
>110dB
> 90dB
>60dB typical
Volume: From Off to 0 dB
MUTE: Yes
Polarity: Yes
HPF (inputs 5-8): 50Hz to 150Hz – 3dB
Metering: VuMeter post Fader
Stereo: On – Off
Inputs: Input 5 to 8, Bypass ON - OFF
Threshold: From -80dBV to +12dBV
Depth: From 0 dB to 80 dB