Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1
Hardware Used
BB
FF
GG
EE
B1
HH
AA
FF
B1
1.1 Connect long cross beam L (B1) and the long cross beam R (B2), then connect them by bolt (BB) / (FF) /
(II) and tighten them by using wrench (JJ). Place cap (HH) on the bolt heads and cap (GG)
on the Nut.
1.2 Connect the beam connector (F1) onto the cross beams (B1/B2) by bolt (AA) / (FF) and tighten them
with wrench (JJ). Install the U-connector (G) onto the cross beams (B1/B2) by bolt (EE) / (FF) and tighten
them with
allen wrench
Repeat the step for another assembly.
G
B1
FF
HH
BB
F1
B2
(LL). Place cap (HH) on the bolt heads.
HH
II
JJ
LL
G
F1
FF
II
GG
EE
FF
G
B1
6
B2
EE
FF
G
B2
B2
Publicidad
