Simpson Strong-Tie Quik Drive T-QDPROINSNA23 Instrucciones De Operación página 3

OPERATING INSTRUCTIONS
ATTACH ADAPTOR TO YOUR SCREWGUN
(If you purchased a complete system with screwgun;
skip this step)
• Remove nose-cone and bit holder from your screwgun
according to manufacturer's directions (most will pull straight off).
• Replace with Quik Drive adaptor made for the screwgun.
®
Follow specific instructions included with Quik Drive adaptor.
INSTALL CORRECT BIT
• Be sure you have the correct bit for the screws you are
driving. It's a good practice to install one of the free bits
included with our screws when you open a new box.
• Remove the attachment and pull the mandrel from the unit.
Extend the bit release key and pry out the old bit.
Put a new bit in place and push against a solid surface until
it snaps in place.
CONNECT ATTACHMENT
TO SCREWGUN OR EXTENSION
• Insert mandrel in extension or screwgun,
slide attachment on and push tight until
the locking lever snaps in place.
• You can rotate the attachment any way
that is desired.
• New tools may be tight and hard to lock
in place. If so, just put the nose against a
solid surface and push down sharply
(see photo at far right).
ATTACH EXTENSION TO SCREWGUN
• Turn the thumbscrew in the "off" direction (G2 = clockwise,
G3 = counter-clockwise) to move the internal clamp out of
the way.
• Insert the screwgun, with adaptor attached, into the end of the
extension. Push tight and tighten thumbscrew.
• If it won't fully insert, start the screwgun slightly until
the drives mesh.
Pointed end first
Screw release lever
(silver) - push down
to unload
LOAD SCREWS
Insert a screw strip pointed end first, until they click in
place. Push release lever to unload.
Insert end of bit
release key into
slot and pry out
the old bit
Locking Lever
flush with top
of tool
NOT locked on
Seat mandrel first,
Check locking lever position to be sure
then add
attachment is locked on
attachment
To remove, unlock and pull
SET DEPTH
Press DEPTH RELEASE to adjust.
Test in scrap material to achieve
optimal setting.
Locking Lever
flush with
Depress at top
side of tool
to release
Locked on
Turn thumbscrew to
open clamp
G2 shown, G3 similar
DEPTH ADJUST HANDLE HEIGHT
RELEASE
G2 shown
If new tool is
hard to lock on,
place nose on
solid surface
and push down
Internal
clamp
G2 shown,
G3 similar
Hex end of
extension
drive shaft