Descargar Imprimir esta página

Siemens SIMATIC FDE Manual De Producto página 72

Publicidad

Certificados y homologaciones
7.4 FCC y Canadá (EE. UU.)
7.4
FCC y Canadá (EE. UU.)
USA
Federal
Communications
Commission
Radio Frequency
Interference Statement
Shielded Cables
Modifications
72
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a resential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded cables must be used with this equipment to maintain compliance with FCC regulations.
Changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment.
SIMATIC FDE Gateway V1.1
Manual de producto, 12/2023, A5E53580799-AE

Publicidad

loading