Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1. Wipe the installation surface
(normally the back of the TV) to
make sure it's dry and clean.
2. Position the camera exactly in
the middle of the top of the TV.
Use a tape measure to determine
this point. Remove the lm cover-
ing the double-sided tape at the
bottom of the camera. Then, stick
it on the determined middle point
on the TV and tighten the base
with the clip located in the back.
4
Back of TV/PC monitor
3. Stick the strip light rmly on the back of the TV, as shown below. Please
follow the direction of the arrows on the strip light.
Note: Although the graphic below shows the strip initial end was placed on
the bottom left corner, you can place it on any corner of the TV, clockwise or
anticlockwise. Go to the Calibration section for more details.
4. Insert the strip lights cable and then power into the port hub at the end of
the camera cable, as shown below .
Once all connections are set up, you'll be ready to complete the Nexxt Home
app con guration and the strip light calibration.
5
Publicidad
