Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
OPERATION
SELECTING DUSK-TO-DAWN
Dusk-to-dawn operation
Dusk to Dawn operation enables the light fixture to automatically turn ON when
dark outside and turn OFF when the sun rises, thus saving you energy.
To enable dusk-to-dawn operation make sure the photocell (B) is exposed to light
•
and is unobstructed.
Ensure the switch powering the outlet connected to the light fixture is turned to
•
the ON position and leave it ON at all times to enable dusk to dawn functionality
to operate automatically.
NOTE: If the photocell (B) is located in an area under heavy shade the
photocell may not detect enough light and may turn the light fixture on
NOTE: To test if the light fixture (A) and photocesll (B) works properly, run power to the fixture and cover the photocell to turn the fixture ON. shine light
into the photocell to see if the fixture turns OFF.
SELECTING CCT AND ADJUSTING BRIGHTNESS
Remove the CCT and DIM cap by selecting the combination on the DIP switches,
Wattages(DIM) and CCT can be set as required.
CCT Selectable
Setting
Wattage Selectable
Setting
CARE AND CLEANING
Shut off the main power supply before cleaning the product. To prolong the original appearance, clean the light fixture with clean water and a
•
soft, damp cloth only.
Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints, solvents or any other chemicals on this light fixture. They
•
could cause a premature deterioration of the finish and may void the warranty.
Do not spray the light fixture with a hose or power washer.
•
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
The light does
There is no power to
not turn ON.
the fixture
The fixture senses
daylight
The light cycles
The photocell light
ON and OFF
sensor is sensing
continuously.
reflected light
The light flickers.
The light fixture wired
through a dimmer
switch
The light stays
The light sensor is in a
ON.
shaded area.
The light sensor is
faulty.
NOTE: Photocell (B) has a short delay in order to reduce its sensitivity to sudden light changes. When testing, shine a light and cover the photocell for a
short time to check if the fixture functions properly.
LED Dust-to-Dawn Area Light Instructions
3000K
4000K
5000K
28W
40W
60W
SOLUTION
• Check if circuit breaker is tripped.
• Confirm wall switch is ON. Verify wiring to the fixture is correct (turn power OFF to fixture beforehand).
Cover the photocell. wait a short time until the fixture turns ON.
• Relocate the light fixture to a location where there is no reflected light.
• OR place the optional photocell cover over the photocell light sensor and use the wall switch to turn the light ON
and OFF.
Do not use a dimmer switch to control the light fixture. Replace the dimmer with a standard ON/OFF switch.
• Shine a flashlight into the light sensor and wait a minute. If the light turns OFF, the fixture should be moved to a
location with enough light in the daylight hours for the light sensor to work.
• OR place the optional opaque cover over the photocell light sensor and use the wall switch to turn the light ON
and OFF.
If the light does not turn OFF when a flashlight is shined on the light sensor for a minute, then the sensor may be
faulty. Please contact customer service.
www.cooperlighting.com
Note:
4000K is default setting
Note:
40W is default setting
IL51870322
B
A
5
Publicidad
