Honeywell HWT-01A Manual Del Usuario página 4

SAFETY WARNING(CONTINUED)
The product should be placed on a flat, solid surface (inclined to less than 6°) to avoid tipping,
falling, and damaging the product due to instability.
The product will generate heat during operation, please keep the area surrounding the product clear
to mitigate heat generation.
DO NOT submerge the product in water or use the product under conditions exceeding the
operating temperature. For example, DO NOT place the lamp above the fireplace, gas, or exhaust
pipe, as well as in bathrooms, outdoors, and other places that deviate from the standard use of the
product. This product is for indoor use only.
Please store the power cord of this product properly, do not place heavy objects on the power cord,
to avoid trampling or damaging it.
Avoid putting your fingers between the connecting rods of the lamp arm when adjusting the angle,
otherwise, injuries such as pinching can occur.
Consult an electrical professional when inspecting and repairing the lamp, non-professional
refurbishing is prone to danger.
If the external cable or cord of the lamp becomes damaged, it should be replaced by professional
repair personnel for safety reasons.
WARNING: To prevent the occurrence of accidents that threaten personal safety
such as lamp damage, falling, electrical shock, fire, and so on, please strictly
follow the instructions for installation and use, do not modify the lamp's structure,
and exchange parts or accessories.
CLEANING AND MAINTENANCE
Please clean and check the lamp regularly. Before care and maintenance, turn off the lamp and
remove the power adapter from the power socket to prevent electrical shock.
When cleaning the lamp, use a soft, lint-free cloth with a little diluted neutral cleaner to wipe the
lamp's body. Do not use alcohol or any other kinds of chemical solvents, such as kerosene, stain
removal oil, etc., as they may damage the lamp's housing.
It is strictly forbidden to use water or other liquids to directly wash any lamp parts.
WARNING: Before cleaning and maintaining the lamp, the power must be cut off
to prevent electrical shock.
EN | 2