Publicidad
Idiomas disponibles
Idiomas disponibles
2) Within 10 seconds, press and release the push-button override switch. Depressing this
switch one time will cause the security system to reset the Hi-Jack mode.
The circuit will not trigger again unless the door is opened and then closed while the vehicle
is running.
Car Locator:
Anytime during the armed mode, if the Lock button is pressed within range of the vehicle, the
siren will chirp 6 times and the parking lights will flash 12 times allowing easy location of the
vehicle in a crowded parking light.
Transmitters Included With This Kit:
The transmitters are programmable and at times it may become necessary to replace trans-
mitters if they become broken or if they are stolen. If this is the case, order replacement
transmitters from Audiovox by going to www.prestigecarsecurity.com. The transmitters
packaged with this kit are PA91 & PA92.
To Program new or replacement transmitters:
1. Enter the vehicle, and turn the ignition key to the "on" position.
2. Press and release the valet/override/program push button switch 3 times.
3. The dash LED will flash one time and the siren will "chirp" 1 time indicating the
system is ready to accept programming for channel 1Arm/Disarm, Lock/Unlock
and Panic.
4. Press and hold the lock button of the first transmitter until the parking lights flash and a long
chirp is heard from the siren
Repeat for each transmitter to be programmed. Note a maximum of 4 transmitters can be
programmed.
Turn the ignition switch off or allow 15 seconds of inactivity to exit the transmitter program
mode.
By completing the above, all four buttons of the transmitters are programmed into their default
location.
Lock
=
Lock / Arm, & Panic
Unlock
=
Unlock / Disarm & Panic
Trunk/Key =
Trunk Release & Panic Cancel, Press & Hold 2.5 seconds to
release
immediately. Press two times to start the vehicle.
Option = Consult your installation center for information on this feature.
Second Vehicle Operation:
Press the Trunk/Key button + the Option button for 2 seconds, the LED flashes 2 times.
Release the buttons, then press any transmitter to select 2nd vehicle mode.
While in the 2nd car mode, press the Trunk/Key button + Option button for 2 seconds, the
LED flashes 1 time to indicate the primary vehicle operation.
When in the second car mode, you can program the transmitter to a second vehicle which
may have a similar Panther Alarm system installed allowing full functional control of both
vehicles.
Battery Replacement :
Use CR2016 X 2 or equivalent.
1) Using a coin pry apart the case where indicated by
the arrow.
2) Carefully separate the top case from the bottom.
3) Carefully remove the discharged batteries from un-
der the clip.
4) Properly dispose of the discharged battery.
5) Replace with two new CR2016 batteries.
6) Carefully align the upper and lower case and press
together until the cases closes securely.
trunk, Press while Panic is sounding to cancel panic
Page 6
128-9109
6 of 16
Publicidad
