Publicidad
Idiomas disponibles
Idiomas disponibles
863Wc Melina Bench — Parts List
Please identify the parts and check that quantities received match those on this list.
If you need to replace a part, refer to the following letter and model name.
Ac — Leg — Qty. 4
F — 3/8" x 2-1/2" Hex Bolt
— Qty. 8
863Wc Melina Bench Assembly Instructions
Fig. 1
Bc
1.
Place the Top Assembly (Bc) face-down on a clean, protected surface. Position each Leg (Ac) at
the apron corners so the holes in the Legs face inward. Place a 3/8"x 2-1/2" Hex Bolt (F) through a Washer (E)
and the predrilled hole in the corner brace and tightly thread into the Insert Nut (G) in each Leg.
See Figures 1 and 1a.
SPECIAL INSTRUCTIONS
I f a top or panel becomes cupped, do not be alarmed. The panel was flat when it was
manufactured. It is a natural characteristic of wood in an unfi nished state to cup
from uneven moisture conditions. The fi gure at the right shows an exaggerated
view of what could happen. This only means that the convex side has
absorbed moisture, or the concave side has dried out.
Usually a cupped panel will equalize and straighten out if both sides are
exposed to similar conditions for a day or so.
Bc — Top Assembly — Qty. 1
G — Insert Nut
— Qty. 8 (inserted)
Tool Required:
9/16" or Adjustable Wrench
Ac
E
F
E — Washer — Qty. 8
H — #8x1-1/4" Pan Head Screw
— Qty. 24 (inserted)
F x 8
Ac
E x 8
E
E
F
Fig. 1a
863Wc – Page 2 – 06/10
Publicidad
