Plugload PL07 Manual Del Usuario

Desplácese hacia abajo para la versión en español.
INTRODUCTION
The PlugLoad PL07 7-outlet Tier 1 Advanced
PowerStrip (APS) is an energy-saving surge protector
that reduces standby power wasted by TV and PC
peripheral electronics. In addition to saving energy, the
APS provides surge protection to safeguard electronics
against damaging power surges.
GETTING TO KNOW THE APS
SURGE LED INDICATOR
When illuminated green, this LED
indicates that the surge protection is
functioning normally. If this LED
extinguishes at any time, the APS
was sacrificed to protect your devices
and must be replaced.
RESETTABLE CIRCUIT BREAKER
The resettable circuit breaker
provides protection for all outlets on
the APS. If no devices are powered or
LEDs lit, press the circuit breaker to
reactivate power.
ALWAYS-ON OUTLETS
The always-on outlets receive
constant power and remain on all of
the time.
INSTALLATION REQUIREMENT
POWER CONNECTION
The APS features a heavy-duty power
cord with an angled, space-saving plug. It
must only be plugged into a grounded
receptacle for surge protection to operate
correctly. All connected devices should be plugged directly
into the APS. Use of an extension cord, adapter or other
power strip in conjunction with the APS will void all
warranties.
The APS may not be used with an aquarium, humidifier, or
any device which may cause condensation or moisture to
enter the APS.
The APS must only be used indoors in a cool, dry location.
The APS should not be located directly next to a
baseboard heater where it is likely to overheat.
Any high-current devices which manufacturers require to
be plugged directly into a receptacle must not be plugged
into the APS.
The total amperage of devices plugged into the APS must
not exceed 15A.
In addition to conditions mentioned above, installation of
the APS must comply with UL installation requirements for
Relocatable Power Taps and the National Electric Code.
CONTROL OUTLET
This current-sensing outlet controls
whether power is supplied to the
switched outlets or not. The control
device (e.g., TV or PC) must be
plugged into this outlet.
ENERGY SAVING OUTLETS
The Energy Saving outlets will
automatically switch off when the
control device (e.g. TV or PC) powers
off or enters a standby state.
PAGE 1