Preparing The Machine For Use; Filling The Solution Tank; Before Using; Pre-Spraying The Carpet - Clarke Clean Track S16 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

A - ENGLISH

PREPARING THE MACHINE FOR USE

FILLING THE SOLUTION TANK

1
Turn the power switch to off (O) and then unplug the machine.
2
Remove the recovery hose. Lift the recovery tank from the machine and set it off to the side.
3
Read the dilution instructions on the chemical container. Then calculate the proper amount of chemical to mix with your machine's solution tank
capacity of water; 7 gallons (26.5 liters) for Clean Track S16 or 11 gallons (42 liters) for Clean Track L 18.
4
Pour the chemical into the solution tank and fi ll the tank with hot water (maximum temperature 54°C/130°F). NOTE: Do not overfi ll the solution
tank. The maximum fi ll point is when the solution level reaches the bottom of the lip on the tank opening. See Figure 4.
5
Put the Recovery Tank back on the machine. NOTE: Make sure the Recovery Tank is properly seated on the Solution Tank.
CAUTION!
Use low-sudsing, liquid detergents designed for carpet extraction.
FIGURE 4
BEFORE USING THE CLEAN TRACK
Thoroughly vacuum the carpet to be cleaned before using the Clean Track automatic extractor.

PRE-SPRAYING THE CARPET

Pre-spray spots and heavy traffi c areas before extracting. Use a hand-held bottle sprayer or a pressurized "Hudson" type sprayer. Mix the pre-spray
according to the chemical manufacturer's directions.

PLAN FOR CLEANING

Before you begin extracting, look at the area to be cleaned and plan your work. Divide the space into sections. Overlap each pass 2 inches (5
cm).
A-8
INSTRUCTIONS FOR USE
Clean Track S16, L18 - 56091055
12/11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Clean track l18

Tabla de contenido