Publicidad
Idiomas disponibles
Idiomas disponibles
P
arts
K
Y
e
s
now
our
lectrIc
KIllet
1
6
1. Lid Handle
2. Steam Vent
3. Glass Lid
a
h
ssemblIng the
andles
1. Do not use skillet without handles
attached.
2. Place left handle onto mounting studs
under skillet pot.
3. Use screwdriver to attach 2 screws
through holes in the leg into the skillet
pot.
4. Place right handle onto mounting studs
under skillet pot.
5. Use screwdriver to attach 2 screws
through holes in the leg into skillet pot.
6. CAUTION: Overtightening can
result in stripping of screws or nuts or
cracking of handle or feet.
I
dentIfIcatIon
2
4. Handle
5. Temperature Controller
6. Skillet Pan
English-4
c
ondItIonIng of the
Before using your new appliance, wash the inside of the pan with warm, soapy
water and dry. When washing the skillet, make sure the temperature controller
3
is removed. Rub a film of cooking or salad oil all over the non-stick coating on
the inside of the pan. Remove any excess oil with a cloth or paper towel.
The OSTER
4
condition it again.
u
5
1. Push the temperature controller firmly into its socket found at the side of
the appliance. Plug into a standard 120 Volt AC outlet.
2. Set the temperature you want by turning the knob on the temperature
controller. The indicator light will come on. Set the temperature of your
choice opposite the indicator light. When the light goes off, the chosen
cooking temperature has been reached. During cooking, the light will blink
on and off indicating the temperature is being maintained. Guidance in the
choice of temperatures is supplied later in this book.
3. It is recommended that you not cook with the Electric Skillet standing on
temperature sensitive surfaces.
4. For simmering, set the temperature controller to SIMMER and wait until
the liquid boils. Turn the knob toward the WARM setting. Set the dial to
this point each time SIMMER is specified in a recipe.
5. Do not use metal utensils in your Electric Skillet as they may damage the
non-stick coating. Wood or plastic coated spatulas are best. If you use
plastic tools, make sure they are suitable for use on hot surfaces.
6. To remove the temperature controller, first unplug from the wall outlet,
then gently remove the controller from the socket.
7. No preheating is needed when using the product.
I
ntroductIon
n
-s
on
tIcK
Electric Skillet is now ready for use and it is unnecessary to
®
o
e
®
sIng the
ster
lectrIc
English-5
c
P
oated
an
s
KIllet
Publicidad
