Publicidad
Idiomas disponibles
Idiomas disponibles
Refer to Figure 1.
Check for shipping damage. If damage has occurred, a claim
must be filled with carrier. Cheek for completeness.
Immediately report missing parts to dealer.
The sander comes assembled as one unit. Additional parts
which need to be fastened to sander, should be located and
accounted for before assembling.
A Sander
B Miter Gauge Assembly
C Work Stop
D Table
E Stud
F Handle withWasher
Not Shown: Abrasive Disc, Knob (2), Foot (4), Mounting
Bracket (4), M6 x 16 Socket Head Bolt (2), M6 x 16 Hex Head
Bolt (4), M6 Lock Washer (2), M6 Flat Washer (6), M6 He_ Nut
(4), 3 and 5mm Hex Wrench and 13mm Open End Wrench.
C
_'_B
Figure 1 - Unpacking Sander
Refer to Figures
2 - 6.
CAUTION:
Do not attempt
assembly
if parts are missing.
Use this manual
to order replacement
parts.
WARNING;
Do not operate
machine
until completely
assem-
bled. Do not operate
machine
until you have completely
read
and understood
this manual
TOOLS
NEEDED
While assembling or adjusting your belt and disc sander, you
will need the following tools:
• 13ram Wrench
• 3 and 5ram Hex Wrenches
• Combination Square
• Phillips Screwdriver
MOUNT
SANDER
Refer to Figures 2 and 3.
Choose a suitable location to mount the sander. The sander
must be installed in a place with ample lightingand correct
power supply.To install sander:
• The sander must be bolted to a firm, level surface.
• Make sure there is plenty of room for moving the work-
piece. There must be enough room that neither operators
nor bystanders will have to stand in line with the wood
while using the tool. Allow room so that belt assembly can
be positioned horizontally.
• Press a foot onto each corner of the base of the sander.
• Sander
can be installed
on a workbench
or a toot stand
(see Recommended
Accessories,
page 13) using bolts, lock
washers
and hex nuts, and mounting
brackets.
Figure 2 - Insert Mounting Brackets into Slots of
Sander Base
•
Figure 3 shows the base dimensions,
mounting
holes and
required
space to allow for table assembly
and belt
assembly
in horizontal
position.
24"
1 0 _
__ira,,=
18"
,,;
Figure 3 - Base Dimension and Required Space
ATTACH ABRASIVE
DISC.
Refer to Figure 4, page 4.
• Remove disc cover by loosening and removing four screws.
• Peel protective paper from the back of the abrasive disc.
• Center the abrasive disc onto the aluminum disc and press
on firmly and evenly.
• Replace disc cover.
Publicidad
