Publicidad
Idiomas disponibles
Idiomas disponibles
5. Mount the blade onto the motor shaft, matching the screw with the shaft slot. Secure the
screws. (Figure1 to 3)
6. Mount the front grill to the rear grill and fix with the grill clip. (Figure1 to 3)
7. Mount the hook or the supporter onto the wall and fix with the spreading screws, then
hang the wall fan onto the wall and make sure the wall mount is secured. (Figure3)
OPERATING INSTRUCTIONS
- Please make sure the switch is in the off position, then insert the power plug into the
specified voltage AC outlet on the date plate.
- The speed is adjusted by moving the knob to the desired setting. The number 0.1.2.3 on
the board indicates off slow moderate and fast in the proper order. The speed of wall fan is
adjusted by speed wire switch:
0 = Off
1 = Low speed
2 = Medium speed
3 = High speed
- To set the fan into oscillation, depress the oscillating knob on the top of the motor
assembly. The fan head will pivot side to side. For stationary operation, pull up the
Oscillating knob. And the wall fan oscillating is controlled by the oscillating wire switch.
- Table fan and wall fan adjust the tilt angle, loose the screws a little. Then adjust the angle
to the desired position, re-tighten the screws, the height of the stand fan is adjusted by
adjusting the height adjustment lock.
1.STAND FAN
Figure 1
1
Front grill
2
Blade
3
Rear grill
4
Motor
5
Switch
6
Stand
7
Base cover
8
Screw
9
Base
Publicidad
