Publicidad
Idiomas disponibles
Idiomas disponibles
ENGINE
FUEL SYSTEM
IMPORTANT:
it is importantto prevent
gum deposits from forming in essential
fuel system parts such as carburetor, fuel
filter, fuel hose, or tank during storage,
Also, experience indicates that alcolol
blended fuels (called gasohol or using
ethanol or methanol) can at_act moisture
which leads to separation and formation
of acids during storage, Acidic gas can
damage the fuel system of an engine
while in storage
• Drain the fuel tank,
• Start the engine andlet it run untilthe fuel
lines and carburetorare empty,
• Never use engine or carburetorcleaner
products in the fuel tank or permanent
damage may occur
• Use fresh fuel next season,,
NOTE: Fuel stabilizeris an acceptable
aitemative in minirnizJng the formationof fuel
gum deposits duringstorage. Add stabilizerto
gasoline infuel tank or storagecontainer,
Always followthe mix ratiofound on stabilizer
container Run engine atleast 10 minutes
after adding stabilizerto allow the stabilizerto
reach the carburetor: Do not drain the gas
tankand carburetorifusing fuel stabilizer:
TROUBLESHOOTING CHART
ENGINEOIL
Drain oil (with engine warm)and reptacewith
clean engine Oilo(See "ENGINE" inthe
Customer Responsibilitiessectionof this
manual),
CYLINDER
• Remove spark plug
. Pour one ounce (29 ml) of oil through spark
plug hole into cylinder:
• Pultstarter handle slowlya few times to
distributeoil,.
, Replacewith new spark plug.
OTHER
, Do not store gasolinefrom one season to
another.
• Replaceyour gasor=ne can if yourcan starts
to rust, Rustandlordirt inyour gasoline will
cause problems
, if possible,store your unit indoorsand cover
it to give protectionfrom dust and dirt.
° Coveryour unit witha suitableprotective
cover thatdoes net retain moisture. Do not
use plastic. Plasticcannotbreathe which
aJlowscondensationto form and will cause
your unit torust,
IMPORTANT: Never cover mower while
engine and exhaust areas are still warm°
CAUTION: Never sto_ethe lawn mower with
gasoline in thetank inside a buildingwhere
fumes may reach an openflame or spark,
Allow theengine to cool beforestoring in any
enclosure,
PROBLEM
CAUSE
Does not start
,, Dirty air filter,
, Out of fuel,,
• Stalefuel
° Waterin fuel
• Spark plug wire is
disconnected,
. Bad spark plug
° Loose blade or broken blade
adapter_
, Control bar inreleased
position,,
• Control bar defective,
CORRECTION
, Clean/replaceair filter,
o Fillfue! tank.
= Drain tank and refillwith
fresh clean fuel,
= Drain fuel tank and
carburetorand refilltank
with freshgasoline°
° Connectwire to plug
- Replacespark plug,
- Tightenblade bolt or
replacebladeadapter:
° Depresscontrol bar to
handle.
. Replacecontrol b ar,
!5
Publicidad
