Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART
PROBLEM
CAUSE
CORRECTION
Does not start
9.
Control bar defective.
9.
Replace
control bar.
(continued)
10.Weak
Battery
10. Charge battery.
11.Disconnected
battery
11.Connect
battery to engine.
connector.
Loss of power
Poor cut -
uneven
Excessive
vibration
Starter rope
hard to pull
1. Rear of lawn mower
housing or cutting blade
dragging in heavy grass.
2. Cutting too much grass.
3. Dirty air filter.
4. Buildup of grass, leaves,
and trash under mower.
5. Too much oil in engine.
6. Walking speed too fast.
1. Worn, bent or loose blade.
2. Wheel heights uneven.
3. Buildup of grass, leaves
and trash under mower.
1. Worn, bent or loose blade.
2. Bent engine crankshaft.
o
2.
3.
4.
Engine flywheel brake is on
when control bar is releasec
Bent engine crankshaft.
Blade adapter broken.
Blade dragging in grass.
1. Set to "Higher Cut"
position.
2. Set to "Higher
Cut"
position.
3. Clean/replace
air filter.
4.
Clean
underside
of mower
housing.
5.
Check
oil level.
6.
Cut at slower walking
speed.
1. Replace blade. Tighten
blade bolt.
2. Set all wheels at same
height.
3. Clean underside of
mower housing.
1. Replace blade. Tighten
blade bolt.
2. Contact a Sears or other
qualified service center.
1. Depress
control
bar to
upper
handle
before
pulling
starter
rope.
2.
Contact
a Sears or other
qualified
service
center.
3. Replace
blade adapter.
4. Move lawn mower to cut
grass or to hard surface.
Loss of drive
1.
Drive wheels not turning
1. Adjust
or replace drive
with drive control engaged,
control cable.
2.
Belt not driving.
2.
Put belt on pulleys or
replace belts if broken.
Grass
catcher
1. Cutting height too low.
1. Raise cutting height.
notfilling(ifso
2.
Lift on blade worn off.
2.
Replace
blade.
equipped)
3.
Catcher not venting air.
3.
Clean grass catcher.
Hard to push
1. Raise cutting height.
1. Grass is too high or wheel
height is too low.
2.
Rear of lawn mower
housing
or cutting
blade
dragging
in grass.
3.
Grass catcher
too full.
4.
Handle
height
position
not
right for you.
2.
Raise rear of lawn mower
housing
one (1) setting
higher.
3.
Empty grass catcher.
4. Adjust
handle height
to
suit.
17
Publicidad
