TM 581
Warranty and coverage
Applicable to all equipment families.
The warranty does not cover damage caused by accidental situations, accidents,
misuse, abuse, neglect or modification of equipment or any part thereof by
unauthorized persons.
The warranty does not cover damage caused by installation and/or improper
operation, or attempted repair by anyone not authorized by Tecnomotor.
In no event will the liability of Tecnomotor will exceed the original cost of
equipment purchased, and will not cover consequential damages, incidental or
collateral.
The Tecnomotor reserves the right to inspect any equipment involved in the case
of request for warranty service.
The repair or replacement decisions are made at the discretion of Tecnomotor or
persons authorized by it.
The repair or replacement as provided under this warranty constitutes the sole
compensation to the consumer.
The Tecnomotor not be liable for any incidental or consequential damages arising
from misuse of equipment of its manufacture.
Introduction
Disther was developed for testing high pressure pumps in the Common Rail
system, acting on the flow control valve (ZME, MPROP, IMV, SCV) and DRV
valves, in addition to controlling PCV valves of synchronized pumps and
measuring the cubic volume of the pump in tests predetermined by the
manufacturers of Common Rail pumps.
Disther does not perform any control over the test bench such as rotation, heating
of the test fluid, etc. The rotation adjustment must be carried out by the bench
operator.
32