Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
THE LINE
1. Remove the spool by firmly pulling
on the tap button.
2. Clean entire surface of hub and
spool.
3.
Replace with a pre-wound
spool
(#71-85837),
or cut a length of 30
feet of 0.065" (1.6 mm) diameter
Craftsman o Pro Trimmer
line. Use
of heavier lines could overload the
unit and damage
unit.
_WARNING:
Never
use wire,
rope, string, etc., which can break off
and become a dangerous
missile.
4.
Insert one end of the line about 1/2
inch (1 cm) into the small hole in-
side the spool.
5. Wind the line evenly and tightly
onto the spool. Wind in the direc-
tion of the arrow found on the
spool.
6.
Push the line into the notch, leav-
ing 3 to 5 inches (7 - 12 cm) un-
wound.
7.
Insert the line into the exit hole in
the hub as shown in the illustra-
tion.
8. Align the notch with the line exit
hole.
9.
Push the spool into the hub until it
snaps into place.
10. Pull on the line extending
outside
the hub to release it from the
notch; otherwise,
the unit will not
function
properly.
Hole
_ "=""- Spool
_t l/_/
t_YJA
Tap ,,f
_
Sutton
,-. _%c7
Line exit hole
USER REPLACEABLE
SERVICE
PARTS
REPLACEMENT
PART
Spool with 0.065" Pro Trimmer Line
Assist Handle
Bolt, Assist Handle,
1/4-20
Wing Nut, Assist Handle
Shield Assembly
PART NUMBER
71-85837
530401991
530401989
530016118
530402672
_IWARNING:
Performthe
follow-
ing steps after each use:
• Stop the unit and disconnect
the
power source when not in use.
• Carry the unit with motor stopped.
• Store the unit so the line limiter
blade cannot cause injury.
• Store unit and extension
cord in-
doors in a high, dry place out of the
reach of children.
Store unit un-
plugged.
• Store unit with all guards in place.
Position unit so that any sharp ob-
ject cannot accidentally
cause injury.
9
Publicidad
