Publicidad
Idiomas disponibles
Idiomas disponibles
rpan
- Pan Reverse
With this function you can reverse the Pan-movement.
• Select "RPAN" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
rtil
- Tilt Reverse
With this function you can reverse the Tilt-movement.
• Select "RTIL" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Switch 16 bit/8 bit
With this function you can switch the device from 16 bit to 8 bit resolution.
• Select "16BI" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] or [DN] to select "ON" in order to set 16 bit, or "OFF" in order to set 8 bit. The channels
PAN Fine and TILT Fine will be disabled.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Adjust dimming speed
With this function you can adjust the dimming speed.
• Select "DIMM" by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm; the display shows "FAST".
• Press [UP] to select "SLOW" or "FAST".
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
Caution:
If several connected devices should be dimmed and there are devices with older software-versions, the
dimm speed SLOW must be selected in order to maintain compatibility!
- Mic sensitivity
With this function, you can select the desired microphone sensitivity between 0 % and 99 %.
• Select "MIC" by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm; the display shows "M-70".
• Press [UP] to select the desired sensitivity.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Status if no DMX-signal
With this function, you can select the status for the case that there is no DMX-signal. You can choose
between „CLOS" for Blackout, „HOLD" for holding the last position, „AUTO" for running the internal
program and „AUDI" for the sound-controlled program-run.
• Select "AUTO" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "CLOS".
• Press [[UP] or [DN] to select between "CLOS", "HOLD", "AUTO" and "AUDI".
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
48/104
00026093.DOC, Version 1.5
Publicidad
