HJM WF40D Instrucciones De Uso página 18

6. Open the clip in the front guard and attach the front guard centre to the middle of the
rear guard and secure by pushing the guards together until they click into position.
7. Fix the front guard with the back guard closing the clip and tighten the locking screw.
MOUNTING INSTRUCTIONS:
1. The attached screws are for mounting the wall bracket directly to a wooden wall. If
mounting to other surface you should use proper anchors. If necessary, call a handy man
for assistance.
2. Choose a convenient location and mount the wall bracket firmly to the wall preferably
close to a power outlet.
3. Mark the position of the two drill holes. Make sure that the holes are absolutely
horizontal then drill the holes. Fix the proper anchors to the wall. NB: the anchors must
be chosen according to the wall surface.
4. Insert the fan onto the anchors by sliding the notch (at the back of the fan) onto the
anchors.
5. Make sure the fan is securely positioned in the anchors.
FAN DIRECTION ADJUSTMENT:
1. Do not attempt to make any adjustment to the direction of the grille and fan assembly
until the fan has been turned off and unplugged from the socket.
2. To adjust the vertical direction of the fan, hold the grid and loosen the knob positioned in
the left side of the body of the fan.
3. Gently tilt the fan until the desired position is reached and fix the position tightening the
knob.
4. Plug the fan back into the socket and turn on the fan.
OPERATING INSTRUCTIONS:
1. Use in a dry place, free of excessive humidity and water.
2. To the set the fan in motion simply pulls the string until you reached the desired speed:
The speed string is the one on the right side and the speed selected will be displayed on
the rotary speed indicator
0=OFF
3. Pull the oscillation control string once (the pull cord on the left side) to make the fan
oscillate. Pull the string again to stop the fan oscillation.
CLEANING AND MAINTENANCE:
• Operate in a dry area, free of excessive humidity and water
• Rotate the timer knob in Off position or rotate speed knob in "0" position to switch OFF
the power and unplug the fan before cleaning
1=LOW 2=MEDIUM 3=HIGH
18