Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFETY INSTRUCTIONS
POWER SOURCE REQUIREMENTS
The power source must be able to supply the necessary current to operate the load. The
Greenworks™ 80-volt battery is the only DC source, this inverter cannot connect to other DC
sources.
W A R N I N G :
Keep ventilation when using batteries.
Cannot mount the power inverter on other position, can just install on the Greenworks™ battery pack.
CONNECTION TO LOAD
The inverter is equipped with a AC power receptacle. Plug the cord from the equipment you
wish to operate into an AC receptacle. The green LED indicator light turns on to indicate that the
inverter is functioning. Make sure the combined load requirement of your equipment does not
exceed inverter's output rating (300W).
The inverter is engineered to be connected directly to standard electrical and electronic
equipment in the manner described above.
Do not connect the power inverter to household or RV AC distribution wiring.
Do not connect the power inverter to any AC load circuit in which the neutral conductor is
connected to ground (earth) or to the negative of the DC (battery) source.
OPERATING ENVIRONMENT
For best operating results, the inverter should be placed on flat surface, such as the ground, car
floor, or other solid surface. The inverter should only be used on a flat surface, such as a dry
ground, car floor, table, patio, or other solid, dry and flat surface.
DRY- Do not allow water and/or other liquids to come into contact with the power inverter.
COOL – Do not place the inverter on or near a heating vent or any piece of equipment which is
generating heat above room temperature. Keep the inverter away from direct sunlight, if at all
possible.
SAFE – Do not use the inverter near flammable materials or in any locations that may
accumulate flammable fumes of gases.
4
Publicidad
