Publicidad
Idiomas disponibles
Idiomas disponibles
• Tilt up the front of the drawer and pull straight
towards you. Then, move the drawer slightly
in the direction of the arrow in the illustration
below, and then pull out.
To re-install
• Insert the drawer into the frame rails and push
back into place.
• Slide the bin in above the desired location and
push down until it stops.
CAUTION
The drawers need to be removed before the glass
shelf above them can be lifted out.
4. Flex Zone
To remove the Flex Zone – Pull the Flex door
out to full extension. Lift the Flex Zone up, pulling
it to your body with both hands.
To re-install the Flex Zone – Open the Flex door
to full extension. Tilt the front of the Flex Zone up,
place the back of the Flex Zone onto the rails, and
then lower the front until the whole Zone rests on
the rails.
DA68-02601G-00.indb 29
If the Flex Zone or LED lighting is not
working, check the connectors [ ( 1 ), ( 2 )
shown below ] for cracks or leaks.
1. Refer to page 12 for disassembly instructions.
2. Open the cap cover rail with a flat-blade
screwdriver.
Using the doors
Ensure that the doors close all the way and are
securely sealed.
When the refrigerator door is only partially open, it
will automatically close. If the door is opened more
than its auto close range, it will remain open. You
must close it manually.
English - 29
2
1
2014. 12. 4.
3:06
Publicidad
