Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada CSA Z94.3) when
using as a blower.
_1_WARNING: To avoid injury to
bystanders, keep them clear of
blowing debris.
A
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
_, CAUTION: To reduce the risk of
hearing damage, wear ear protec-
tors when using the Vac/blower for
extended hours or when using it in
a noisy area.
2. Insert the locking end of the "Pos-I-
Lock _'' hose into the blowing port of the
Vac. The hose should snap into place.
To remove the hose from the Vac,
press the release button in the hose
assembly and pull the hose out of the
Vac inlet.
3. (Optional) Attach extension wand to
opposite end of hose.
4. Turn Vac on and you are ready to use
your Vac as a blower.
Craftsman recommended
accessories
are
available at Sears retail stores and
sears.com. The Sears Car Nozzle Stock
No. 17839 is recommended
for blowing
debris.
Locking
Hose End
g Port
Extension
_nd
•Car
Nozzle
Maintenance
Filter
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning filter.
NOTE: This filter is made of high quality
paper designed to stop very small parti-
cles of dust. The filter can be used for wet
or dry pick up. Handle the filter carefully
when removing to clean or installing it.
Creases in the filter pleats may occur
from installation but creases will not affect
the performance of the filter.
Filter
Cleaning
Your filter should be cleaned often to
maintain peak Vac performance.
Be sure to dry the filter before storing or
picking up dry debris.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use a
filter with holes or tears in it. Even a small
hole can cause a lot of dust to come out
of your Vac. Replace it immediately.
Filter Removal
To remove the filter for cleaning or
replacement,
unscrew the filter nut from
the filter cage, remove filter plate and lift
off filter.
IMPORTANT: To reduce the risk of
damage to the blower wheel and motor,
always reinstall the filter before using the
Vac for dry material pickup.
Cleaning
A Dry Filter
10
Publicidad
