Philips SCM7880/12 Manual Del Usuario página 4

SCM7880 17-09-2007
4 Functional overview (fig. A)
PHILIPS
1
• Lights up when a 5V device is charging (when no
device is connected, the PHILIPS logo will flash).
• Flashes when the device is fully charged.
Foldable power plug
2
Connects to the wall outlet.
Battery check button
3
Activates the power indicator.
USB port
4
Connects to 5V DC devices (mobile telephones,
MP3 players, etc.).
Power indicator
5
Indicates the battery status.
Reset
6
Resets the USB adapter back to factory default
settings.
5 Operation
Charging the internal battery (fig. B)
Press the battery check button (3).
1
> One, two or three LEDs light up in the power
indicator (5), indicating the current battery status.
If all four LEDs light up, the battery is fully charged.
Insert the power plug (2) into a wall outlet.
2
> The power indicator LEDs (5) will flash one after
another, indicating that the battery is being charged.
> When all LEDs light continuously the battery is fully
charged.
Disconnect the USB adapter from the wall outlet.
3
All manuals and user guides at all-guides.com
13:32 Pagina 4
Charging devices - preparation
Check the maximum input voltage (V DC) of the
1
device you wish to connect. For this see the user
manual that came with the device.
Make sure the device does not consume more current
2
(mA) than 450 mA.
3 Check what connector tip is required for your device.
See the compatibility sheet for the proper tip for your
device.
Charging 5V devices (fig. C)
You can charge a 5V device in two ways:
• Charge directly from the internal battery.
• Insert the power plug (2) into a wall outlet.
1 Insert the plug of the USB cable into the USB port (4).
2 Connect the connector tip to the USB cable.
3 Insert the connector tip into the power supply jack of
the device.
> PHILIPS lights up when a device is charging.
> PHILIPS will flash when the device is fully charged.
4 Disconnect the device from the USB adapter.
Note:
If you are unable to solve a problem by following the
above hints, try resetting the USB adapter by pressing
RESET.The RESET button is recessed to prevent
accidental reset of the USB adapter. Use a paperclip to
gently press the RESET button.
6 Technical specifications
• Battery type: Lithium polymer
• Rated input: 110V - 240V AC (60/50Hz)
• Rated output: 5.4V DC, max. 450 mA
• Battery capacity: 1000 mAh
• Recharging time: 2-3 hours
• Operating temperature: 0ºC - 45ºC
• Size: 80.5 x 57.7 x 40.8 mm (h x w x d)
• Weight: 116 g
4