Publicidad
Idiomas disponibles
Idiomas disponibles
Setting Timer
• After power or temperature setting for cooking, you can opt
for timer setting. Press the timer button to activate. The indi-
cator light with light up.
• Press the increase setting or decrease setting button to in-
crease or decrease the operation time (Range: 0 min ~ 180
mins). Default setting is 0 min.
• When the timer is set, it will be stored automatically within 5
seconds. The appliance will then start operation. It will dis-
play the remaining time and the power setting / temperature
setting alternately on the display.
• The appliance will go into Standby mode when the set time
is elapsed.
• If the set time is reduced to "0 min" manually, the appliance
will go into Standby mode instantly.
Note:
1. Press and hold the increase setting button or decrease set-
ting button for fast adjustment.
2. Every time, you press any button on the panel, a short beep
sound will be heard to alert the user.
3. After an extended period of operation, it is normal for the
cooling fan inside to continue running in Standby mode for
some time. Before disconnect the appliance, wait until the
cooling fan stops running.
4. The appliance's surface is still hot after switch to Standby
mode. Wait completely cool down before touching.
5. If no any button on the control panel is pressed during oper-
ation for 2 hours, the appliance will then switch to Standby
mode automatically.
Error code identification
Error codes
Possible cause
shown on
the display
E 1
The temperature
of the appliance is
too high
Cooling fan defective
E 2
The pan or pot is
overheated.
Possibly, the pan
becomes empty and
appliance will shut
down for protection.
E 3
The supply voltage
is abnormal. (Supply
voltage is too high or
too low)
Possible solution
Clear all obstacles that
around the appliance.
Disconnect the appli-
ance, remove the pan
or pot, wait until the
appliance is completely
cool down.
Contact the supplier.
Disconnect the appli-
ance, remove the pan
or pot, wait until the
appliance is completely
cool down. And make
sure water is inside
the pan.
Make sure that the
appliance is connected
to a suitable electrical
power supply.
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
• Food residues should be regularly cleaned and removed from
the appliance. If the appliance is not cleaned properly, it will
reduce its lifespan and may result in a dangerous condition
during use.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for clean-
ing. Do not use petrol or solvents!
• No parts are dishwasher safe.
Maintenance
• Check the operation of the appliance regularly to prevent se-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
GB
9
Publicidad
