Publicidad
Idiomas disponibles
Idiomas disponibles
Air Compressor
Pump (not shown):
Compresses air into the air tank.
Working air is not available until the
compressor
has raised the air tank
pressure above that required at the
air outlet.
Check Valve:
When the air
compressor
is
operating, the
check valve
is "open",
allowing
compressed
air to enter
the air tank.
When the
air compressor
reaches "cut-out"
pressure, the check valve "closes",
allowing air pressure to remain inside
the air tank.
How to Use Your Unit
How to Stop:
1.
Set the On/Auto/Off
lever to
"Off".
Before
Starting
Break-in
instructions
_Risk
of Unsafe
Operation,
Serious
damage may result if the following
break-in
instructions
are not
cmosemy followed.
This procedure is required before the
air compressor
is put into service and
when the check valve or a complete
compressor pump has been replaced.
1.
Make sure the On/Auto/Off
lever
is in the "Off" position.
NOTE: If quick connect is installed,
pull coupler back until it clicks to
prevent air from escaping through the
quick connect.
2.
Plug the power cord into the
correct branch circuit receptacle.
(Refer to "Voltage and Circuit
Protection" paragraph in the
Installation section of this
manua!.)
3.
Open the drain vane fully
(counter-clockwise)
to permit
air to escape and prevent air
pressure build up in the air tank
during the break-in period.
4.
Move the On/Auto/Off
lever
to "On/Auto" position. The
compressor
will start.
5.
Run the compressor for 15
minutes. Make sure the drain
valve is open and there is
minimal air pressure build-up
in
tank.
6.
After 15 minutes, close the drain
valve (clockwise). The air receiver
will fill to "cut-out"
pressure and
the motor will stop.
The compressor
is now ready for use.
Before
Each
Start-Up:
1.
Place On/Auto/Off
lever to "Off".
2.
Pull regulator knob out, turn
counter-clockwise
until it stops.
Push knob in to lock in place.
3.
Attach hose and accessories.
NOTE: The hose or accessory
will require a quick connect plug
if the air outlet is equipped with a
quick connect.
pressure causes a hazardous
risk of
bursting,
Check the manufacturer's
maximum
pressure rating for air
tools and accessories,
The regulator
outlet pressure must never exceed
the maximum
pressure rating,
13-ENG
A13640
Publicidad
