Lorex Aurora Serie Guía De Configuración Rápida página 5

English
1. Use the mounting template to drill holes for screws, then insert the drywall anchors. Drill a hole for the
camera's cable if you plan to run it through the mounting surface.
2. Use the Allen key to loosen the camera's adjustment screws, and then remove the dome cover from the
camera base.
3. Use the screws to mount the camera base to the surface. If you are running cables along a wall/ceiling, make
sure to pass the cable through the cable notch.
4. Feed the camera's cable through the camera base, and then connect the cables (see page 10).
5. Position your camera as needed, and then attach the dome cover to the camera base by tightening the
adjustment screws.
6. Remove the vinyl film from the camera lens once your installation is complete.
7
Mounting Surface
Surface de montage
Superficie de montaje
Mounting Template
Gabarit de montage
Plantilla de montaje
Drywall Anchor
Chevilles pour cloison sèche
Taquetes para yeso
Camera
Caméra
Cámara
Mounting Screw
Vis de montage
Tornillos de montaje
8