Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator.
To help promote better health, the water filter
removes unwanted particles from your water.
However, it does not sterilize the water or destroy
microorganisms. You may need to purchase a
water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20 ~ 125 psi (138 ~ 862 kPa) is
required.
If the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled.
To do this, press the water dispenser lever until the
water runs from the water outlet.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and a ¼" compression nut.
Connecting to the water supply line
1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Cold water line
Pipe clamp
Shut off valve
DA68-03029A-06.indb 16
All manuals and user guides at all-guides.com
English - 16
3. Connect the water line installation kit to the
shut off valve.
Cold water line
Pipe clamp
Shut off valve
Connecting the water supply line to the
refrigerator
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Use Copper Tubing
Use Plastic Tubing
• ¼" copper tubing
• ¼" plastic tubing
• ¼" compression nut
(1pc)
• ¼" compression nut
• Ferrule (2pc)
Refrigerator
Compression Nut
Ferrule
(Not supplied)
Copper tubing
or
(Not supplied)
Household water supply line
Water line installation kit
→ Molded end (Bulb)
(1pc)
Plastic Tubing
(Assembled)
Compression
Fitting (Assembled)
Molded end
(Bulb)
Compression
nut (B) (1/4")
(Not supplied)
Plastic tubing (B)
(Not supplied)
2015. 5. 8.
9:18
Publicidad
